The Foundry: Drilling an Air Hole

At this point we had a cast foundry base, made out of sand and plaster of paris. To see how that was made, see the tutorial here.  Before we first test it though, we had to make one modification, and that was to drill a 30mm diameter hole in the side of it.

The hole from the outside
The hole from the outside

The idea of the hole is to allow air to come in and fuel the fire. The theory goes that the air comes in the side, and the resultant fumes (like smoke) leave via the opening at the top. It makes sense because heat rises, and takes all those hot resultant gasses up with it. Note that we don’t really care about the fumes coming off the fire at this point, we just want as much oxygen as possible to get to the coals. If hot exhaust fumes are leaving via the same hole as the oxygen, but going the opposite direction, they will interact with each other, slow each other down, and make the furnace much more inefficient.

Also notice the hole is angled down into the base of the furnace. This isn’t by accident, we want that hole to do two things, pump air into the base of the fire, and not let anything go back up the hole. This hole in the future may contain a fan, to pump more air in. We don’t want the embers flying back up the pipe and breaking the fan during use.

To drill the hole we used a hammer drill bought from Aldi, and a 30mm masonry drill bit, these parts can be pretty cheap if you search around, and the hole doesn’t have to be this exact size. Use what you can find, and make sure you get help when doing the drilling. As always, safety is important, and safety glasses and gloves would be a good idea. if one person steadies the foundry, while the other drills, it is much easier. Go slow, so that the plaster on the inside doesn’t break too much. It is easy to be too eager and create large cracks and chips, which could mean an entire restart.

The hole from the inside
The hole from the inside, notice the dust, and broken parts around the hole.

Although this was a shorter post, the next one will be about the first tests! As always, thanks for reading, and I hope to be along with another update soon. If you guys have any tips, questions, or want to show your foundry, please post in the comments below.